Technics SL-J33 - Page 5

1
Follow
the
steps
1~5
of
the
“Before
begining
the
play”
on
page
4.
Press the program buttons in the desired order.
(The indicator will illuminate.)
If the tune is programmed by mistake, press the button again to cancel the selection.
For discs containing more than 8 tunes:
When the 8th tune is selected, all remaining songs will be played in succession.
Tune numbers higher than 8 cannot be selected.
what tune is playing.)
If
the
start
button
is
pressed
during
play,
the
repeat
indicator
will
flash
and
play
will
resume
from
the
beginning of the program sequence.
Note:
© There is a delay of about 10 seconds between tunes
in a program sequence.
Program
play
is
only
possible
with
30-cm
(12”)
discs.
The current
program
can be altered
by
repeating
steps
2 and 3 above.
3 Press. (Play starts and the program indicator flashes
Press to search forward or backward
over the tune being played.
Press the cueing switch to resume play.
The tonearm can only be moved over the
tune currently being played. :
Press
to
repeat
the
programmed
tune.
Press
to
stop
the
play
temporarily.
(The indicator will illuminate.) Press again to resume the play.
To stop repeat play, press this switch again
or press the stop/clear button.
Press to stop the play.
(The tonearm will automatically return to the start position, then the
rotation will stop.)
(The programmed play and the repeat play will be cancelled.)
The
following
types
of
discs
should
be
played
manually.
~- ® Discs
other
than
17- or 30-cm
discs
* Badly
warped
discs
® Lightweight
discs
such
as “Soundsheets”
¢ Transparent
or colored
discs.
Disc groove scale
Ascale with 1 mm graduations that is useful for determining the
tonearm position.
Follow
steps
1~3
of
“Before
beginning
play”
on
page
4.
2 22) "zua_| Size selector (size)
bea]
Set to “manual”.
Speed selector (speed)
Ot
[1] Set to disc’s speed.
4 Close the upper cabinet.
Press the cueing switch. Move the
(Play will start.) tonearm to the
desired position.
Notes:
1.
After
listening
is
finished,
set
both
the
size
selector
and
the
speed
selector
to
the
“auto”
position.
2. Programmed play is not possible in the manual mode.
After
listening
is
finished,
the
power
switch
of
this
unit
should
be
turned
“off”.
ae;