Technics SL-J33 - Page 6

Adjustments
Notes
14.
After
listening
is
finished,
be
sure
to
set
the
sensitivity
selector
to
the
“M”
position.
2.
\f
the
operations
described
above
do
not
solve
the
problem,
play
the
disc
manually.
In
case
of
short
spaces
between
tunes
or
highly
modulated
grooves,
the
blank
detection
circuit
may
not
operate
properly.
Short
spaces
between
tunes
Specified
tune
is
skipped
------
Set
the
sensitivity
selector
over
and
the
next
tune
is
to
the
“H”
position.
played
instead.
L_M_H
‘eS
oile
2
———
Highly
modulated
grooves
Play
starts
from
the
middle
------
Set
the
sensitivity
selector
of
a
tune
or
stops
at
the
to
the
“L”
position.
middle
of
a
tune.
io
Me
—I-—
The
stylus-set-down
position
is
preset
at
the
factory.
If,
during
the
programmed
play,
no
sound
is
heard
even
when
the
stylus
reaches
the
beginning
of
the
specified
tune
or,
no
sound
is
heard
for
a
long
time
after
the
stylus
contacts
the
disc,
make
the
adjustment.
Remove.
eee
oe Stylus set-down
position adjustment
knob
Sensitivity selector
Notes
¢
The
first
tune
of
a
disc
can
not
be
adjusted.
Adjustment
is
possible
only
for
tunes
2
through
8.
© If between-tune gaps are extremely short or contains music
and/or when an eccentric disc is used, this adjustment will not
correct
the
problem
and
the
disc
should
be
played
manually.
Replacement
1.
Set
the
sensitivity
selector
to
the
“H”
position
2.
Remove
the
cap,
then
rotate
the
stylus
set-down
position
adjustment
knob as described
below:
If the first few seconds of the
specified tune are not audible
or the beginning of the tune
after the specified tune is
played,
rotate towards the “out”
direction (to the right).
1-2 clicks moves
~the tonearm about
40.1 mm.
If no sound is heard for a long
time after the stylus contacts the
disc (more than 20 seconds) or
the tonearm lifts before the end
of the tune,
rotate towards the “in” direction
(to the left).
j——
Always
return
the
sensitivity
selector
to
“M”
position
after
completing
the
above
adjustment.
If
noise
is
heard
from
new
discs,
the
stylus
is
probably
worn.
Replace
it with
a new
one.
(Refer
to
the
operating
instructions
of
the
cartridge.)
The plug-in type of cartridge is already designed to match this
unit in every respect: weight, correct stylus pressure, stylus tip
position, center of gravity, etc. This means that there’s no longer
any need for troublesome connection of lead wires or
adjustment of the stylus pressure.
(Refer to page 3.)