Technics SL-P110 - Page 12

H HOW TO REPLACE IC’S (Small outline type)
Replacing procedure Cautions
1 | Reduce the amount of solder on (Exsmple) H-130 * Recommended tool
each pin of the integrated circuitby | = -~ WY , | e Special soldering iron
use of a solder sucker. * H605M and H-130.
* HB05E and H-130.
Solder ¢ Do not touch the soldering iron to
sucker the area for a long time. It may
otherwise cause removal of the
2 | Melt the solder on the pin (one elec- print foil.
trode) with the soldering iron. * When shifting the pin upward, do
the job quickly while the solder is
meilting. If the solder is hard, it
may cause removal or breakage of
the print foil.
¢ When using a pencil type solder-
ing iron.
1. Completely remove the solder
from each IC pin by use of solder
sucker.
@}(
/& 2. Raise each pin by means of an
3 | While the solder is melting, shift
the pin upward by the soldering iron
to remove it from the foil.
eyeleteer, hold the pliers then
remove IC package from P.C.B.
4 | Remove each pin from the foil
according to the above-mentioned
procedure. R v e
* Special soldering iron .
(Refer to Technical informetion, ORDER NO. GADS4125486T1)..For U.S.A. and Canada
(Refer to Technical Information;:GRDER NO. GAD84115476T8)._For others
*H—605 Spot Heater (hot-air solder iron)
This device that uses hot air to melt solder was developed to remove Flat-Package ICs, RHCs and chip parts.
¢H—-605M (For 120V power source) oH—617 Twin Nozzle (for spot heater)
o H—605E (For 200V/220V/240V power source) Special nozzle for the removal of RHCs and chip
resistors. (Nozzle diameter: 1.0mm X 2)
*eH—130 Slim Pencil Solder lron
An ultrasmali ceramic heater solder iron is extremely
handy for soldering chip parts, RHCs, ICs etc., to high-
density circuit boards.
Features:
*Rated power: 100V, 15W
e Max. temp.: 400°C
e Heater: ceramic (long life)
s Insulation resistance: 100MQ
eLength: 178 mm
e Weight: 16g (not including cord)
H—130 eH—-131, H—V13 Cap Bits
) Solder tip for the slim pencif Solder Iron is composed
y
of
a
bit
holder
and
a
corrosion
resistance
solder
tip.
‘;2 fi s, H—131 Permits changing of solder tips even while still hot.
¢ / H—V13 e Solder tip: 0.3mm
H—617