file:///E|/_MANUALS/TECHNICS/technics_sl-pd7nasvc_[ET]/NA/SL-PD7/SVC/s0500000000x.html[30/09/2009 12:14:27]
5 Protection Circuitry
TOP PREVIOUS NEXT
The protection circuitry may have operated if either of the following conditions are noticed:
No sound is heard when the power is turned on.
Stops during a performance.
The function of this circuitry is to prevent circuitry damage if, for example, the positive and negative speaker
connection wires are “shorted”, or if speaker systems with an impedance less than the indicated rated impedance
ofthe amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first turned off and then on
again.
TOP PREVIOUS NEXT
To Next Page
Loading...
Need help?
General