Technics sl-pd887 Service Manual

WACCESSORIES
[AC powor SUPPLY COrd << so ecs eves ccsecesesescesesees 1 BOs ‘Stereo connection Power plug
1WsA0733 (EB)] [RIA0036-K (GNJ]—_(RYA0019-2K (E, EG, GO) cable ws 16, adaptor.......... 1 pe,
§SIP22493) ABIPSTIS7 (60)
emig § xt
MECONNECTIONS
Bi connie Shai! et aide wea, alk
Se Oe Teme Te CAUTION FORAG
ee
” POWER SUPPLY CORD ON PAGE 4
‘Although the figure below shows the AC power supply cord
being connected to a household AC outlet, if the amplifier (or BEFORE THE FOLLOWING CONNEC-
receiver) is equipped with an AC outlet, connect the cord to that TIONS.
ie a Aa ct ig ne ee
‘Stereo
connection
cable
‘Set
the
voltage
selector
to
the
voltage
setting
for
the
area.
‘White
(L)
jin
which
the
unit
will
be
used.
Red (A) (Use a minus (—) screwdriver]
If the power supply in your area is 117 V or 120 V, set to
the "127 V" position
Note that this unit will be seriously damaged if this setting
Is not made correctly.
It the power plug will not fit your socket,
Use the power plug adaptor (included).
Ampiitior
or receiver
[For (E, £8, EG, GC) areas)
Insertion of Connector
Even when the connector is pertectty in-
a Serted, depending on the type of inlet used,
the front part of the connector may jut out
{as shown in the drawing,
However there is no problem using the unit.
Household
[For (GC) area oniy} Paap
MREPLACEMENT OF THE FOOT Heat meted posts
1. Remove the 4 heat melted posts on the Bottom board
ass'y with a pair of nippers or similar tool. Foot
2. To replace the foot (RKA00S3-A) on the Bottom
board ass'y meit the 4 posts with a soldering iron Bottom board assly Soldering iron
or install it with a screw (XTB3+6,). Sem
Foot(RKAO0S3-A)

Technics sl-pd887 Specifications

General

Brand	Technics
Model	sl-pd887
Category	CD Player
Language	English