Technics SL-PG420A - Page 2

SL-PG420A |
Before placement Notes of placement
Two
transport
security
devices
are
secured
to
prevent
the
optical
™@
This
unit
is
a
precision
instrument.
Be
sure
to
place
it
ona
@
pickup from damage during transport. _ flat surface.
Be sure to release them before use. ™@ Avoid places such as the following:
eNear any equipment or device that generates strong magnetism.
LOCKED Turn © RELEASED On any heat-generating equipment or device, or in any place
CG; rs where the temperature is high (35°C or higher).
jo >~ | Extremely cold places (5°C or below).
=> > : ng - eNear a tuner or TV (It may cause noise in the broadcast, or
= Pull a 5 disturbance of the TV picture.) ; ; rae
\; ait @ When carrying or storing the unit, handle it with care so
that it is not subjected to any strong bumps.
Always remove the compact disc before storing the unit for any
period of time.
@ To avoid problems due to vibration.
®Do not place a book or similar object under this unit.
@Do not route the connection cables (of this or other units) across
the operation panel, across the top, or under the unit.
Insert them here after removing.
Turn clockwise by 90° to secure
them.
Soft cloth or similar material (to
- prevent scratches)
- 3 a 5
Note: ;
When transporting the unit, be sure to-remove the compact disc
from inside the unit. And replace the transport security devices
again following the reverse order not to.damage the optical pickup.
Wi CLEANING OF LENS
lf the lens is stained causing sound skip or operation Cautions:
failure, open the top cover by pressing the open Do not directly apply the cleaner solution to the
button, and clean the lens. lens. Do not apply too much solution to the cotton
rod or otherwise the solution will flow into the player.
¢ To remove dust or dirt ¢ Wipe the lens carefully. Do not give too much stress
Blow the lens with the blower provided in the cleaning to the lens or otherwise it may scratch the lens or
kit to remove dust or dirt. cause optical pickup trouble.
e If the solution should be too much applied, wipe the
lens with a dry cotton rod.
Lens cleaning kit (Part No. : SZZP1038C)
Dust or dirt. Fingerprint
¢ To remove fingerprint
If the blower is not enough, moisten the cotton rod
with the lens cleaner solution and wipe the lens with
it from center of the lens to outside.
Cleaner
Blower
Wi ACCESSORIES
¢ AC power supply cord... 1 pc. Stereo connection cable.. 1 pc. * Remote control transmitter e Batteries
eae (E, ae (SJP2249-3) (EUR64798) : Use two UM-4,
SJA193 (EB) “AAA” (R08) size
(1.5V) batteries.