Technics SL-PG480A

Program Plav
With this function, vou can program up to 20 tracks in anv order vou
like.
ts
10
While the disc is stopped:
Press PROGRAM.
If the button is pressed while the disc is
plaving, that track is programmed as the
first.
liluminates.
Press l44/44 or PP /PPI to
specify the desired track
number.
For example:
To specify track no. 3, press >> /hPr1
3 times.
ee MA ATI
Ce karat a
Repeat steps 2 and 3 until vou
have completed the desired
entrv.
If you make a mistake when pressing a
track number, press CLEAR.
For example, if you specify tracks 5, 3
and 2 in that order:
Total playing time of
Last track number programmed programmed tracks
Number of tracks programmed
Press P.
Tracks are played in the programmed
order, and then play stops automatically.
Program contents are stored even after
playback ends.
To play the same program contents
again, press >.
To switch back to playback in the original! track
order:
PROGRAM
While the disc is playing:
Press PROGRAM.
The program contents will also be
erased.
The disc is played from that point until the
end and then stops automatically.
To cancel program mode:
While the disc is stopped:
Press E.
if the disc is playing, press the button
twice.
To specify a track number with the remote control:
1 to 9:
1 8
eo =
10 or higher:
210 1 9 0 kd
CISCO SS (= @
(Tens digit) (Ones digit)
For example:
Specifying track no. 25
210 2 5
OOO
Specifying track no. 30
z210 3 0 `
OOO
Step 3 is not necessary when using the remote control.