Technics SL-PS670A

Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Same simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit} to locate a convenient service center, or consult your dealer for instructions.
|
Probable cause(s)
After inserting a disc, the | ts the disc inserted properly?
tray will not close even |
after pressing #4 OPEN/ i
CLOSE. :
Even after inserting a disc, Is the disc inserted upside-down?
Suggested remedy
' Re-insert the disc. —
Re-insert the disc.
the total number of tracks Is the disc dirty? i Wipe with a soft cloth.
and other indicators do not :
appear on the display. Is the disc scratched?
Even after pressing », disc | is the disc extremely warped?
playback does not begin. : Are you using a non-standard disc?
Has moisture condensation occurred?
Use anciher disc.
Tum the unit on and wait an hour before using.
Specified areas do not play | ts the disc dirty?
Property.
There is noise from the ;
tuner or disturbance on the
TY screen.
Wipe with a soft cloth.
; Caused by high-frequency signals of this unit. @Use the unit farther away from the tuner or TV.
elf the tuner’s or TV's antenna is the indoor type,
__ use an outdoor one.
The remote contre! does Are the batteries inserted with the & and © ends
not work. reversed?
Are the batteries worn out?
Wipe this unit with a soft cloth.
If the surfaces are extremely dirty, wipe clean with a cloth which has
been dipped in a weak soap-and-water solution and wrung out
thoroughly, and then wipe again with a dry cloth.
®Do not use alcohol, thinners, etc.
eWhen using chemically treated cloths, refer to the explanations
provided with them,
About moisture
Moisture may form on the Jens in the following cases...
#*/mmediately after a heater has been turned on.
@/n a steamy or very humid room.
eWhen the unit is suddenly moved fram a cofd anvironment to a
warm one.
if moisture forms inside this unit, ii may not work properly. in this
case, tum the unit on and wait about one hour for the moisture to
evaporate.
23