Technics SL-PS840 User Manual

Preparations (continued)
Connections
6
Before making connections, be sure that the power of this unit and
ail other system components is first turned off.
See the operating instructions of the amplifier or the cassette deck
for details.
FOR UNITED KINGDOM ONLY
BE SURE TO READ THE CAUTION FOR AC
POWER SUPPLY CORD ON PAGE 3 BE¬
FORE PROCEEDING TO STEP 4.
® CT)
DIGITAL
OUT
SYNCHRO
OPTICAL
EDIT
OUT
Of
so
LUOKAN 1 LASERLAITE
KLASS1 LAS ER APPARAT
Rear panel
AC IN%
VOLT ADJ
JL
[o
3 I
l ,
tLJ
of this unit
(Tutoteen takaosassa)
(Apparatens baksida)
Note:
The configuration of the AC
outlet and AC power supply
cord differs according to area.
(red) (white)
Voltage selector
(VOLT ADJ)
Household
AC outlet
, 1 2 3
1 Connect the stereo connection cable (in¬
cluded) to the “CD” or “AUX” terminals of the
amplifier.
When using the synchro edit function, be sure to connect the
stereo connection cable to the amplifier even if the optical-fiber
cable has been connected. (See pages 22-25.)
2 Connect the synchro edit cable (included with
the cassette deck) to the “SYNCHRO EDIT”
terminal of the Technics cassette deck.
3 Connect the optical-fiber cable (not included)
to the “DIGITAL INPUT” terminal of the ampli¬
fier.
4
For areas except Europe, Australia and New Zealand
Set the voltage selector (VOLT ADJ) to the
voltage setting for the area in which the unit will
be used.
•Use a minus (-) screwdriver.
•Note that this unit will be seriously damaged If this setting is not
made correctly.
• If the power supply in your area is 117 V or 120 V, set to the
"127 V" position.
4 Connect the AC power supply cord (included)
to the “AC OUTLET” of the amplifier or the
household AC outlet.
This terminal can be used for connection with other equipment
ttiat has a digital input terminal, such as an amplifier, by using
an optical-fiber cable. A dust-protection cap is inserted in this
terminal. Remove this cap only when a connection is to be
made to this terminal.
For areas except Europe, Australia and New Zealand
If the power plug will not fit your socket, use the power plug
adaptor (included).
For areas except Australia and New Zealand
Insertion of Connector
Even when the connector is per¬
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as
shown in the drawing.
However there is no problem
using the unit.

Technics SL-PS840 Specifications

General

Brand	Technics
Model	SL-PS840
Category	CD Player
Language	English