Technics SL-XP505 User Manual

stereo Earphones (continued)
•When pressing the button twice or three times in succession, press it within one second and
at equal intervals.
•Volume can be controlled with the phones level control of the main unit. Make sure to adjust
the phones level control of the unit to 5-7 position.
•The Operation Indicator lights during playing and flashes in the stop mode. (The indicator is
turned off in a power off condition.)
Hold switch
If setting the hold state by sliding down the Hold switch, the Remote control button can not be
pressed. This prevents the Remote control button is pressed by mistake.
Maintenance
(Be sure to switch operation "OFF" first. If
you are using the AC adaptor, disconnect it
before cleaning.)
■ If the lens is dirty...
A dirty lens will cause sound skipping and,
if the lens is very dirty, disc play may not be
possible. Open the disc holder and clean
the lens as shown in the figure.
Cleaning kit (option)
Part number; SZZP1038C
■ If discs are dirty...
Clean with a soft, damp cloth, and wipe dry.
O X
Always from the Scratches caused by
center to outward. wiping in this direction
can create noise.
■ If the cabinet is dirty...
Wipe with a soft cloth. If the cabinet is very
dirty, dampen the cloth with a weak solution
of neutral detergent and water, and then
wipe clean.
Lens

Technics SL-XP505 Specifications

Power

power supply	DC 4.5 V
power consumption (AC adaptor)	3 W
power consumption (battery)	0.8 W (DC 3 V)

Audio Specifications

frequency response	20-20000 Hz
dynamic range	more than 94 dB
output voltage	1.0 V (50 kO)

Weight and Dimensions

dimensions	128x29.7x148 mm
weight	345 g with batteries