Technics SL-XP505 User Manual

Troubleshooting Guide
If the unit does not operate properly, check ail of the following points, as well as connections
and the control positions of all components to this unit, before requesting professional
servicing. This table does not include checks for mistaken connections or incorrect settings of
other components. If the problem is not solved by this table or is not included in the problems
listed below, contact your Technics dealer for assistance.
Problem
Causes
Remedy
Disc holder cannot be
opened.
•The disc holder is locked.
•Release the lock state.
Disc holder cannot
be closed.
•The disc is not properly
inserted.
•Take it out and insert it
again.
Disc is inserted but
number of tracks and
playing time are not
displayed.
•The Hold Switch is set to
“HOLD” position.
•Disc is inserted upside
down.
•Disc is dirty.
•Disc is scratched,
•Disc is seriously warped.
•A non-standard disc is
inserted.
•Dew has formed Inside the
player.
• Release the hold state.
•Insert disc again properly.
•Wipe clean with soft cloth.
•Use a new disc.
•Use a new disc.
•Use only discs with the
® mark.
•Wait about 1 hour, then
turn on again.
About Compact Discs
Noise can result if the disc is dirty,
scratched, warped, etc. Please note the fol-
bwing points.
■ Compact disc identification...
•Do not attach any type of paper, label etc.
to the disc.
•If moisture forms on the disc, wipe it off
with a soft, dry, lint-free cloth before using
the disc.
COMPACT
MME
DIGITAL AUDIO
Use only compact discs
bearing this mark.
■ Handling notes
I •Be careful not to scratch the surface with
fingernails or other sharp objects.
> •00 not bend the disc.
•Do not dry discs with a hair dryer.
•Do not write on the label side with a ball-
point pe n, hard pencil or other hard writing
■ Storage hints
Store the disc only in its own case.
Keep discs away from...
•Locations exposed to direct sunlight.
•Heating equipment and places where the
temperature is high.
•Places where there is high humidity or
excessive dust.
•In the glove compartment or rear ledge of
an automobile.

Technics SL-XP505 Specifications

Power

power supply	DC 4.5 V
power consumption (AC adaptor)	3 W
power consumption (battery)	0.8 W (DC 3 V)

Audio Specifications

frequency response	20-20000 Hz
dynamic range	more than 94 dB
output voltage	1.0 V (50 kO)

Weight and Dimensions

dimensions	128x29.7x148 mm
weight	345 g with batteries