Fitting The Wand Tonearm® to a Technics SL1200 family turntable
(SL1200 / SL1210 / SL120 / SL1500 etc)
To be read in conjunction with The Wand User Guide. (Thanks to Andy & Hans for photos of their turntables)
Step 5: Screw mounting plate to turntable Step 6; Add the earthing cable
(This may not be needed if your Technics is earthed)
Step 7; Position the spindle sideways using Step 8; Replace the bottom covers.
protractor (& tighten screws)
Step 9; Add the arm rest (Wand Plus shown here) Step 10; Revert to The Wand User Guide
www.thewandtonearm.com
©January 2014 design build listen Ltd. v2
I have really been enjoying the
extra detail and just sheer get up
and go that it provides,
Andy, Timaru, New Zealand
To Previous Page
Loading...
