Technics ST-7300

mg DIAL CORD INSTALLATION GUIDE
@ For threading a fresh cord, proceed as follws.
1. Prepare a fresh cord more than 200cm (78-3/8"') in
length.
2. Bring the variable capacitor into a state where the drum
is completely turned to the right (maximum capacity and
lowest frequency for the variable capacitor).
3. Direct the cord in the order from 1 to 9.
4. Stretch the cord in such a tension as the spring length is
elongated by 1.5 times that of the original state.
5. Fix the knot of the cord with the bond.
—— fe ot
3 Turns
Orum
m ACCESSORIES
A3 (SJP5213)
Al (SSA251) A2 (SJP2129-5)
P7(& Accessories)
Printed in Japan
ST-7300 7703-8000 @