Need help?Do you have a question about the Technics ST-8080 and is the answer not in the manual?
This switch is used to turn the power on and off.
This control is used for adjustment of the output level of this unit.
Eliminates noises during FM broadcast selection and changes FM reception to 'stereo' or 'monaural'.
Blends high frequency tones for FM stereo to eliminate background noise and hiss.
Helps pinpoint the best, least distorted tuning position for FM broadcasts.
Used to adjust the dial pointer near the frequency of the desired station for optimum reception.
Used to tune the desired FM or AM broadcast frequency for optimum reception.
Used to select FM, AM, or 'rec level check' modes for reception or recording.
Illuminates in red when the dial pointer tunes to a station broadcasting in multiplex stereo.
Instructions for operating the unit for FM broadcasts, including amplifier and unit settings.
Instructions for operating the unit for AM broadcasts, similar to FM operation.
Steps for recording FM and AM broadcasts onto a tape deck using amplifier connections.
Instructions for connecting the unit directly to a tape deck for recording.
How to connect and position the included FM antenna for optimal reception.
Guidance on selecting a special FM antenna based on signal strength and location.
Details on 300-ohm vs. 75-ohm coaxial cables and impedance matching.
How obstacles affect signals and cause distortion; placement to avoid reflected waves.
Install antenna away from roads, neon signs, and electrical sources to prevent noise.
Proper antenna direction and height for optimal FM reception and signal quality.
Antenna placement relative to buildings, other antennas, and safety near power lines.
Positioning the built-in ferrite-bar antenna for optimal AM reception.
Connecting and positioning an outdoor wire antenna for weak AM signal areas.
Using a stereo amplifier to detect multi-path distortion by adjusting antenna position.
Using an oscilloscope to visually detect and minimize multi-path distortion.
Technical specifications for the FM tuner section, including frequency range and antenna terminals.
Technical specifications for the AM tuner section, including frequency range and sensitivity.
General specifications including output voltage, power consumption, dimensions, and weight.
Graph showing output level and separation characteristics against modulation frequency.
Graph showing output signal level and S/N ratio against input signal level.
Graph illustrating selectivity curves showing interference signal level against detuned frequency.
Graph showing meter deflection against signal level for the signal strength meter.
Warning about using the unit with a voltage different than the rated voltage and direct current.
Precautions for connecting the power cord, avoiding wet hands and not pulling the cord.
Recommendations for unit placement regarding direct sunlight and ventilation.
Warning to keep heating equipment away from the unit to prevent deformation or fire.
Caution against spraying insecticide on the unit to prevent damage or fire.
To Next Page
General
