Technics ST-CA1080

Mi LOCATION OF CONTROLS
Stereo tuner section
@) JOG control
@ Set button
@) External source input select but-
ton
@ Internal source input select but-
ton
©) Volume contro!
© Remote control signal sensor
® Clock/timer button
Tuning mode select button
@) Record timer button
Play timer button
MI SETTING THE TIME
This is a 24-hours display clock.
These instructions explain how to set the
timer for 16:25 (4:25 p.m.) on Wednesday.
I Switch on the power on fhe
power amplifier.
2 @ Press CLOCK/TIMER to se-
lect “CLOCK”.
The “CLOCK” display will soon disap-
pear, but you can proceed to the next
step within 22 seconds.
@ Press SET.
3 @- Turn JOG to select the day.
@ Press SET.
4 @ Turn JOG to select the hour.
@ Press SET.
5 @ Turn JOG to select the min-
utes.
@ Press SET to finish setting
the time.
The display will return to the previous
display after about 2 seconds.
When “0:00: flashes on the display:
It appears when you connect the power sup-
ply cord for the first time or if there has been
a power failure.
If this happens, reset the time.
If the minutes setting has gone
wrong:
1. Press CLOCK/TIMER.
2. Press SET 3 times.
3. Turn JOG to set the minute, and then
press SET.
To display the clock again:
Press CLOCK/TIMER.
To return to the previous display, press
CLOCK/TIMER four times. (or when 22 sec-
onds have passed, the previous display will
be returned automatically.)
| ST-CA1080
©
=
Ol 0
itt ey
SELECT
SELECT
SELECT