Need help?Do you have a question about the Technics SU-8080 and is the answer not in the manual?
General| Damping Factor | 50 |
|---|---|
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Power Output | 80W per channel into 8Ω (stereo) |
| Output | 80W (8Ω) |
| Channel Separation | 55dB (MM) |
| Signal to Noise Ratio | 76dB (MM), 95dB (line) |
Detailed specifications for the power output, distortion, and frequency response of the amplifier's power section.
Input sensitivity, impedance, and load impedance specifications for the pre-amplifier stage.
Identification and labeling of all controls and connectors on the front panel of the amplifier.
Explanation of the power limiter circuit's function and operation to protect speakers and amplifier from overload.
Detailed block diagram illustrating the signal flow, including tone control and input/output stages.
Detailed schematic diagrams for the input selector, tape monitor, and output connections.
Explanation of the power limiter's function and safety warnings related to its operation.
General guidelines and required instruments for performing alignment procedures on the unit.
Diagrams showing adjustable points and detailed procedures for power limiter adjustment.
To Next Page
