Technics SU-R1000

19
English
Operations
(19)
Using analog audio input device
Do not input the audio signal from REC
OUT/PRE OUT terminals to the analog
audio input terminals of this unit. Doing so
may cause malfunction.
Connecting a power amplifier,
subwoofer, etc.
You can connect the power amplifier, subwoofer,
etc. with analog audio cable (not supplied) to
output the analog audio signals.
AUDIOIN
Analog audio cable
(not supplied)
Power amplifier,
Subwoofer, etc.
1 Disconnect the AC power supply cord.
2 Connect this unit and a power
amplifier, subwoofer, etc.
3 Connect the AC power supply cord to
this unit. ( 12)
4 Press the unit on/off button to the
[
] position.
Note
• For details, refer to the operating instructions of
the connected device.
• The audio signal output from the power
amplifier, subwoofer, etc. connected to PRE
OUT terminals can be enable/disable. ( 21)
Connecting a recording equipment
When connecting a recording equipment to this
unit, use the analog audio cable (not supplied)
and connect REC IN terminal with the audio
output terminals of the connected equipment,
connect REC OUT terminals with the audio input
terminals of the connected equipment.
• Press [REC IN] to switch the input source to
“REC IN”.
AUDIOOUT
Analog audio cable
(not supplied)
Recording equipment
Recording input
terminals
(REC IN, AUX IN)
1 Disconnect the AC power supply cord.
2 Connect this unit and a recording
equipment.
3 Connect the AC power supply cord to
this unit. ( 12)
4 Press the unit on/off button to the
[
] position.
Note
• The choppy audio occurs in output audio signal
when switching the input source.
• The audio signal output from recording
equipment connected to REC OUT terminals
can be enable/disable. ( 21)