Technics SU-V2X - Rear Panel Connections and Speaker Configuration; Speaker Impedance Selector Guide; Regional Power Supply Variations

(Switched) AC outlets
layback
Tape IDA tape 'P ayback)
(Unswitched) ({XA] area only)
(Rec
out)
Main
speaker
{R)
Ground
(R) (L) (expect for [XL] area)
Voltage selector
(110V ~—»1 20V-——»220V-~——»240V)
(For [EK}, [XL], [XA] areas only)
Speaker impedance selector
(Rec out) ( gg Main or remote 8~162. _ Main or remote 4 ~62. )
Tape 2 Main and remote 16022 , ~— Main and remote 8].
(Playback)
Tuner input
CD input
Remote speaker
Video/aux input
e Speaker impedance selector
Set to the position corresponding to the impedance of the speaker systems being Note that, if 2 pairs of speaker systems are used at the same
used. time, determine the composite impedance as described below.
If this setting is not correctly made, the result may be a deterioration of
performance.
* If either the main or the remote speaker systems are used: Bee “Ee
4~60,(8—~=): ~ a eeobaan Fat cneaks systems
. =
re aa of a=68. ns connected to “MAIN” terminals
Re=impedance of speaker systems
For
speaker
impedance
of
8~160.
connected
to
‘‘REMOTE”
terminals
* If both main and remote speaker systems are used:
80. (a~-):
For speaker impedance of 80 or more and less than 162.
160. (.~8):
Note:
For speaker impedance of 160.
Be sure to make this setting before switching the power ‘‘on”.
®@ The power supply for this unit varies depending upon the areas. Also, the parts used for power supply are different.
So, refer to the circuit diagram (Separate service manual: Order No. HAD84072860C8—A) and the replacement parts list.
* [XA], [EK] and [XL] areas are provided with voltage selector.
* 220V (50/60Hz) for Continental Europe. (Except for United Kingdom)
* 110V/120V/220V/240V (50/60Hz) for [XA], [EK] and [XL] areas.
* Phono input capacitance is about 150pF.