Computer Connection
These settings are used to select the mode related to MIDI signal flow when a personal computer is connected to the USB terminal
of this instrument.
• When connecting to a personal computer, install the USB driver on the included CD-ROM to the computer first. (Refer to the
separate manual for more information.)
1. Turn off the power to this instrument.
2. Connect a personal computer to the USB ter-
minal on the rear of this instrument.
3. Turn on the power to this instrument.
4. On the MIDI MENU display, select COM-
PUTER CONNECTION.
• The display looks similar to the following.
5. Use the ∧ and ∨ buttons to select a mode.
NORMAL:
Ordinary mode
PC as master:
The mode which is appropriate for data transmission
PR as master:
The mode when this instrument is used as the master
keyboard.
PR as slave:
The mode when this instrument is used as a slave instru-
ment.
INTERFACE:
The mode when this instrument is used as a connecting
device between a PC with only USB terminals and an in-
strument with only MIDI terminals.
MIDI
Part XII MIDI
134
QQTG0665
To Next Page
Loading...
