Technics SX-PX107

DISASSEMBLY INSTRUCTIONS
Removing the top cover (Fig. 5) [5] Removing the control panel ornamert
1. Remove the top cover holding screws (@ 4 pcs.). 1. Remove the control panel (see step [3]).
2. Slide the top-cover forward and lift up. 2. Remove the CP P.C.B. (see step [4]).
(As shown by the arrow.) 3. Release the control panel ornament holding daws.
[2] Removing the keyboard cover
1. Remove the top cover (see step [1]).
2. Close the keyboard cover completely so that the
gears at the rear of the keyboard cover become
free from the guide rails.
3. Lift the keyboard cover up.
[Fig. 5]
[3] Removing the control panel (Fig. 6)
1. Remove the keyboard cover (see step [2)).
2. Remove the contro! panel holding screws (@ 3
pcs.).
3..Remove the control pane! as shown in Figure 6.
[6] Removing the keyboard assembly
1. Remove the control panel (see step [8])..
2. Remove the keyboard ass’y holding screws lo-
cated on the bottom of the cabinet (® 10 pcs.).
[4] Removing the P.C.B.
1. Remove the control panel (see step [3}).
2. Remove the main volume knob.
3. Remove the CP P.C.B. mounting screws (@ 6 Keyboard Assembly
pes.).
wee volume knob
Hu \
if TAS
[Fig. 8]