Technics SX-PX201

HOW TO ASSEMBLE THE PIANO
KEYBOARD RANGES
To prevent the piano unit from falling off the stand, secure it firmly with the screws.
pilebais,
4 brass-colored screws.
Side panel
: . Pedal box
Screw (Brass-colored)
[Fig. 1]
Assemble the side paneis and the pedal box with the B]
Place the piano unit on the stand and secure it to the
stand.
(Black: PX201/
Brown: PX201M) 1 C4; Es | Giti Bis! Diet Far! Azs
wl Ds Fe Ais Cte Eo Ges Bar Dso Fas Aor Cao Eas Gar Bot Dea Fer Ast Cea Eee Gn Bro Dre Fox Kes Coo
[Fig. 3]
a
rs
(2) Place the stand upright. Secure the crossboard to the
front of the L-shaped brackets with 4 screws.
Crossboard
(Black: PX201/
|| Brown: PX201M)
L-shaped brackets
IFig. 2]
Connect the pedal cord and power cord to their
sockets located rear of the piano unit as shown below.
| Dt Gite (rz ize Atzs
Dts
“© Middle ©
a iy Re
Fees mig Diss Goo jes P70 Ata 79 Goa Gio ges
Aisa | Disa iGtas:
CAE A A A i
Ces; E52; Gos, Boo) Dao! Fas! Aso’ Cs2| Ese; Gsoi Bes} Des! Foo Aza, Cre! Exo] Gas: Ber:
Power cord
INITIAL SETTING
Wf INITIAL SETTING
2. Press the INITIAL key.
[Fig. 4]
1. While pressing the MODE SET button.
The initia! setting function is used to return to the original factory settings, and to reset the customer settings and misoperations.
The selected sound and various functions, MIDI settings are inttialized with this operation.
|
Press the INITIAL key while the MODE SET button is presse Or turn on the POWER switch while pressing the INITIAL kay.