Technics SX-PX663

The following MIDI functions can be set.
The DIGITAL EFFECT button and some of the SOUND
buttons, when used in conjunction with the MODE SET
button, serve to set the following MIDI functions.
| Function / оп (when indicator is lit)
The piano can be used as a multiple
sound generator, and data can be received
on each MIDI channel,
off (when indicator is not lit)
e This piano cannot be used as a multiple
sound generator. Data can be received
only on the set MIDI basic channel. In
this case, the produced sound
corresponds to the selected sound as
indicated on the panel (default status).
e |n the initialized state, the MIDI channel and sound assignment that can be used on
this instrument is as shown below (PX664: the ORGAN PRESETS becomes the sound
that is selected at that time).
PX662 souno
GAANO VRON ERAO ERAO: WI is ë STR кын
o o o o o 9 o o
ea
PX664 SOUND
kd GRAND UPRIGHT EPANO! EPIANOZ icu ru
о
3
HARPSI WIRES
o o о о о с о
PANO -——
e When the power is turned on or when this instrument is initialized, the sounds for each
channel that were changed by receiving PROGRAM CHANGE numbers return to the
sounds indicated on the panel.
Data is received only on MIDI channels
which are matched (default status).
e For assigning this instrument's MIDI
channels, refer to page 18.
PROGRAM CHANGE data is not
transmitted/received.
Data is received for all MIDI channels.
PROGRAM CHANGE data is
transmitted/received (default status).
e You can also transmit data for any
PROGRAM CHANGE number. (Refer to
page 21.)
o Please refer to page 21 for information
about the program change number of
each sound button.
PEDAL Pedal operation data is transmitted/ Pedal operation data is not transmitted/
D received (default status). received.
ECT The DIGITAL EFFECT on/off status is The DIGITAL EFFECT on/off status is not
EFF transmitted/received (default status). transmitted/received.
When this instruments TRANSPOSE When this instruments TRANSPOSE
TRANSPOSE function is active, note numbers of the function is active, note numbers of the
LOCAL
CONTROL
transposed notes are transmitted. played keys (non-transposed notes) are
e MULTI TIMBRE and OMNI ON cannot both be turned on at the same time.
PROGRAM
CHANGE
transmitted (default status).
The performance from this instrument does
not sound from this instrument. Set to off
when this instrument is to be used only to
transmit data to connected equipment.
The performance from this instrument also
sounds from this instrument (default status).
e When the POWER is turned on, the
LOCAL CONTROL is set to on.
19
QQTGO635