15
6. A steam cleaner is not to be used.
Connecting the hob to the mains power supply
1. If the cable is damaged or needs replacing, this should be done by an
after-sales technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed wi
th a minimum gap of 3mm between the
contacts.
3. The installer must ensure that the correct electrical connection has been made
and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly qualified
person.
The power supply should be connected in compliance with the relevant
standard,or a single-pole circuit breaker.the method of connection is shown
below.
If the total number of heating unit of the appliance you choose is not less than 4, the appliance can
be connected directly to the mains by single-phase electric connection, as shown below.
Yellow / Green
Black
Brown
Blue
220-240V~
2
3
4
N
L2
L1
1
220-240V~
25A~
1
2
3
4
Yellow / Green
Black
Brown
Blue
220-240V~
380-415V~
220-240V~
1
2
3
4
1
2
3
4
L1
L2
N
To Next Page
Loading...
Need help?
General
