9
DAB DISPLAY MODES
When playing a DAB station you can change the information
on the display by changing the display mode.
To change the display mode from the default of
Multiplex name:
Press the • INFO button repeatedly to cycle through the
options listed in the chart below.
DISPLAY MODES
MULTIPLEX NAME (GROUP NAME): is the name of the DAB
Multiplex that is currently tuned.
TIME & DATE: Shows the current time and date. Time and
date are updated by broadcasted information.
DLS (SCROLLING TEXT): This is a scrolling message giving
real-time information - song titles, news headlines, etc.
SIGNAL STRENGTH: This bargraph indicates the quality of
the signal being received. The maximum signal strength
displayed is indicated by 8 bar segments.
In low signal areas, adjusting the aerial to increase the signal
strength indication will improve reception quality.
PROGRAMME TYPE: This describes (when available) the style
of the programme being broadcast.
BIT RATE: DAB allows broadcasters to vary the BIT RATE (or
the amount by which an audio signal can be compressed)
depending on the type of broadcast. This enables the amount
of stations on a multiplex to be maximised. Speech and News
are often broadcast at a lower Bit Rate; music needs a higher
Bit Rate for good delity.
ALARM 1 STATUS: Briey displays the status of ALARM 1, then
returns to display Multiplex name..
ALARM 2 STATUS: Displays the status of ALARM 2, then
returns to display Multiplex name.
FM DISPLAY MODES
Pressing the INFO button repeatedly when in FM mode
will switch the display to show the status of ALARM 1, then
ALARM 2, then returns to the FM radio display.
To Next Page
Loading...
Need help?
General
