8
GETTING STARTED
FM RADIO AERIAL
Before using your unit for FM reception, unwrap and fully
extend the aerial wire. In use, you may need to adjust the
position of the aerial wire for maximum signal strength.
CONNECTING POWER
Check that the mains voltage marked on the rating plate •
on the back panel is the same as the voltage in your
area.
Plug the mains plug into the wall socket and switch the •
mains power on at the wall.
Switch on the main power switch, located on the rear •
panel of the unit.
The unit will switch on, set to Standby, and the display will
light.
POWER CONTROL
To switch the unit on, press the • STANDBY/ON button or
the
button on the remote control.
The unit will switch on and the display will brighten.
To switch the unit o, press the • STANDBY/ON button or
the
button on the remote control.
The unit will switch o and the display will dim.
Auto-standby
If the unit is switched on, but not playing and with no user
operation (for example, if a CD has stopped playing) for 15
minutes, it will automatically set to Standby .
Display brightness
Pressing any button on the font panel or remote control
(except STANDBY/ON) while the unit is set to Standby will
brighten the display momentarily (to read the clock).
SETTING THE CLOCK
The clock is set when the unit is set to Standby.
To set the clock:
Press and • hold the MEM/C-ADJ button.
HOUR will be displayed, with 12 or 24 ashing.
Press the • { or } button to select your preference of 12
or 24 hour clock display.
Press the • MEM/C-ADJ button to conrm this setting.
The hours digits on the display will now ash.
Press the • { or } button to set the hours digits to the
correct time.
Press the • MEM/C-ADJ button to conrm this setting.
The minutes digits on the display will now ash.
Press the • { or } button to set the minutes digits to
the correct time.
Press the • MEM/C-ADJ button to conrm this setting.
The unit will now set to Standby with the time displayed.
SELECTING A FUNCTION
You can choose from the following functions:
Play music from a docked iPod.•
Play from an external source connected to the AUX (Line) •
input.
Play FM radio (TUNER).•
CD or MP3 disc playback.•
Play music les from a USB drive.•
Play music les from a Flash card.•
To change the function:
Press the FUNCTION button repeatedly to scroll through the
function options listed above.
ADJUSTING THE VOLUME
To increase the volume:
Press the • VOLUME + button.
To decrease the volume:
Press the • VOLUME - button.
To mute the volume:
Press the • MUTE button on the remote control.
The sound from the speakers will be muted.
To unmute the volume:
Press the • MUTE button on the remote control.
The sound from the speakers will return to the last volume level
set.
DISPLAYING THE CLOCK
The clock is displayed when the unit set to Standby.
To display the clock at any other time, press and • hold the
MEM/C-ADJ button.
The display will change to ‘clock’ for a few seconds.
To Next Page
Loading...
Need help?
General
