ATTACHING AND REMOVING THE BATTERY
CHARGING
Disconnect the player from the power supply. Switch the POWER ON/OFF
switch on the player to
The battery attaches to the rear of the player. Line up the centre section of
the battery with the groove in the base in the player and press gently until
the battery locks in place. To release, press the button the side of the
battery and thenremove it.
It takes about 5 hours to charge the battery. A fully charged battery can
power the unit for about 2.5 hours.
Plug one end of the AC power adapter into the DC jack on the side of the
player, then plug the other end into the AC power outlet. Make sure the
player is in “Power Off” mode. Once fully charged, the indicator LED will
turn off. At this point you may remove the wall plug.
You cannot operate the player via the battery when charging is taking
place. If you switch the player on with the AC adaptor plugged in, the
battery is immediatelydisconnected and the charging light will go out.
OFF
Press To
Release
Line the battery up
& press to attach
BATTERY CARE & STORAGE
POWER CONNECTIONS
Recharge the battery when fully spent in order to maximizeits life.
Never recharge a batterywhich is fully or almost fully charged.
Youcan connect the playerto a suitable 9VDC power supply.
A suitable AC/DC power adaptor is provided with the player. Alternatively,
you can purchase from a motor accessory store a standard 12V vehicle
power supply.
Ensure the polarity of the power jack matches the drawing.
The DVD player contains a NI-MH battery pack. There is a risk of fire and
burns if the battery packis handled improperly.
Do not disassemble, crush, puncture, short external contacts, or dispose
of in fire or water.
Do not attempt to open or service the battery pack. Replace only with the
battery pack designatedfor this product.
Discard used batteries in accordance with recycling regulations in force in
your area.
6
PASSWORD: .
E
ENTER
ENTER
.
ENTER
Page Headings
PREFERENCE
The default System Password is
nter the old password withthe number keys
Press to confirm
Enter the new password using the number keypad
Press to confirm
RE-ENTER this password to confirm
Press to confirm. The new password is stored.
To avoid the possibility of others using the default password to bypass
your settings, you can record this master password in another area and
delete it from this manual or store the manual in a safe place.
Press to take you to the at the top of the screen
Press to take you to the page
To change this password:
At the prompt:
(OK)
At the prompt:
(OK)
At the prompt:
(OK)
NOTE: The parental setting is not affected by the default reset function.
(see next page). The master password 3308 is always effective even
after you have selected yourown password and changed it.
Password setting should be carriedout from the handset only.
twice
3308
3308
From the Menu
Press to take you to the page
The choices are:
Set these to personal taste
Press to take you to at the top of the screen
Press to take you to the page
* Brightness can also be set using the Brightness Control on the Player.
Select
Press to confirm
HEADER
VIDEO QUALITY SETUP
BRIGHTNESS, CONTRAST,HUE, SATURATION:
3 times Page Headings
PASSWORDSETUP
CHANGING THE PASSWORD
CHANGE
ENTER
(OK)
Please Enter Old Password
Old Password
New Password
Confirm
OK
-- Password Setup Page --
Password Change
Change Password
-- Video Quality Setup --
Brightness 00
Contrast 00
Go To Video Setup Page
Hue 00
Brightness
Saturation 00
Contrast
Saturation
0
0
0
Hue
0
15
To Next Page
Loading...
Need help?
General
