English - 7 -
Main Interface
When the box is switched on from stand-by mode for
the fi rst time or after fi rst time installation, the following
menu message will be displayed.
After hard disk initializing process, First Time
Installation Menu window is displayed on the screen.
In this window, set the TV type with “
”/“ ” keys and
press OK to continue.
Then “Do you want to start an automatic channel
scan?” pop-up menu is displayed. Auto search can
be started by selecting the “Yes” button. The box
will automatically fi nd the channels and store them
for you.
To start installation process, select “Yes”, to cancel
select “No”.
The set-top box will automatically tune to the channels.
You can press the “MENU” button at any time during
the process.
Menu System
Main menu is accessed by pressing the MENU key
on the remote control. Navigate with “
”/“ ” keys
among the menus and press OK to activate menus.
In some sub-menus, press the BACK button to return
to the previous menu, otherwise, use it to exit from
the menu. In all menus there is an Info banner at the
bottom of the screen. These are functions that can be
used in the current menu.
The Main Menu is accessed, pressing the MENU
button. The items accessed through the Main Menu
are:
1.)Channel List
2.)Programme guide
3.)Timers
4.)Recording Library
5.)Setup
Channel List
Channel list is the place where the channels are
managed. The following operations can be performed
in this menu:
1. Navigating the whole list of channels
2. Deleting unwanted channels
3. Renaming channels
4. Adding locks to channels
5. Setting the favourite list
Channel table is the place where the channels are
managed.
To Next Page
Loading...
General