TechniSat DIGITRADIO 10 C - Page 103

103
DE
EN
FR
NL
5.3.2 Audio connection to stereo equipment, active speaker
> Use the audio output (4) to connect the device to e.g. the AUDIO IN on a
stereo system or an AV amplifier. Use the supplied audio connection cable to
do so (a special cable may be required, depending on the AV amplifier input).
5.3.3 Connecting the mains adapter
> Connect the supplied USB cable to the mains adapter and aach this to the
port marked DC IN (5) on the reverse of the DIGITRADIO 10 C. Then connect
the power supply to the mains.
Ensure that the operating voltage of the power supply unit matches the mains
voltage before you insert it into the wall socket.
5.3.4 Inserting baeries in the remote control
> Open the baery compartment at the rear of the remote control by pushing it
in the direction of the arrow.