TechniSat DIGITRADIO 21 IR

64
15.4 Date and time seings
15.4.1 Manually seing the date/time
Depending on the seing for time updates (Section 15.4.2), the date and time may
have to be set manually.
> In the [System Seings] submenu, select [Time/Date] > [Set Time/Date] and
press the SCROLL/SELECT knob.
> The first digits (day) of the date flash and can be changed using the SCROLL/
SELECT knob.
> Press the SCROLL/SELECT knob to save the seing.
> The next date digits (month) then start to flash and can again be changed as
described above.
> Press the SCROLL/SELECT knob aer each additional seing to go to the next
seing.
> Proceed with the time in the same way as described above.
> Aer all seings have been applied and the SCROLL/SELECT knob has been
pressed for the final time, [Saved] appears on the display.
15.4.2 Time update
Here you can specify whether time updates should be carried out automatically
via DAB+, FM or the Internet, or whether you wish to enter them manually (Section
15.4.1).
> In the [System Seings] submenu, select [Time/Date] > [Time Update] and
press the SCROLL/SELECT knob.
> Use the SCROLL/SELECT knob to select one of the following options:
[Update from DAB] (update via DAB+)
[Update from FM] (update only via FM)
[Update from NET] (update only via the Internet)
[No Updates] (time/date must be entered manually, see Section 15.4.1).
> Press the SCROLL/SELECT knob to save the seing.
15.4.3 Seing the time format
Under Set format you can activate the 12 or 24 hour format.
> In the [System Seings] submenu, select [Time/Date] > [Set Format] and
press the SCROLL/SELECT knob.
> Use the SCROLL/SELECT knob to select the following options:
[24 hours]
[12 hours]
> Press the SCROLL/SELECT knob to save.