EasyManua.ls Logo

TechniSat DIGITRADIO 380 CD IR

TechniSat DIGITRADIO 380 CD IR
148 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
- Replace baeries that are losing power in good time.
- Leaking baeries can cause damage to the remote control.
- If the device is not to be used for a prolonged period, remove the baeries
from the remote control.
- Important instructions for disposal: Baeries may contain toxic substances
that are hazardous to the environment. Therefore, it is imperative to dispose
of the baeries according to the legal provisions in force. Never dispose of
baeries in normal household waste.
6.4 General device functionality
Seings and functions can be carried out both using the buons on the device and
with the remote control. The description of the operation in this instruction manual
refers to the buons on the remote control.
6.4.1 Switching on the device
> You can use the On/Standby (3) buon on the device or the On/Standby
(14) buon on the remote control to switch the device on or back to standby.
Aer switching on for the first time, you can launch the set-up wizard
(Section 17.8). Here you can set the date and time either viaDAB/FM, Internet
or have no update (manual). The device will then aempt to establish a
connection to a WiFi network. To do so, select the corresponding WiFi
network and, if required, enter the WiFi password using the remote control.
6.4.2 Switching o the device
> You can use the On/Standby (3) buon on the device or On/Standby (14)
on the remote control to switch the device on or back to standby. The date
and time are shown in the display.
6.4.3 Operating the device with the remote control
With the infrared remote control you can operate the most important device
functions from the comfort of your armchair. When operating the device with the
remote control, please take into account the following points:
> Point the remote control at the front of the device.
> Visual contact between the transmier and the receiver must be guaranteed.
> If the range of the remote control reduces, replace the baeries.
The maximum range is approximately 5 metres from the front of the device.

Table of Contents

Related product manuals