TechniSat DIGITRADIO 380 CD IR

68
> Change the value with the  or  buons and then press OK.
This preset can be retrieved at any time in My EQ.
17.2 Audio stream quality
The quality of the audio stream may be adapted to the Internet speed. The higher
the quality, the higher the data transfer rate.
> Press the MENU buon and then select [System seings] > [Audio stream
quality].
> Selecta quality level and press the OK buon to save.
17.3 Internet seings
> Press the MENU buon and then select [System seings] > [Internet
seings].
In this menu you will find some seings and information about Internet connection.
> Select [Network wizard] to establish a WiFi connection.
The network wizard shows you all the WiFi stations within range. Use the
/ and OK buons to select the WiFi network you recognise and enter the
password using the displayed keyboard. Then select and press the
OK buon. If the password entered is correct, a connection to the network is
now established. The signal bars
in the status bar of the display indicate
whether a connection exists.
To cancel the input, select and press the OK buon. If you make a
mistake, you can delete the last leer you entered by pressing .
17.3.1 WPS connection
> Select [WPS] if your router has the WPS function. This establishes a direct
connection to the router without having to enter the - WiFi password.
Whether the WiFi network has the WPS function is indicated by the [WPS]
text in front of the network name.
The WPS function can also be activated directly via the menu item [PBC
WLAN establishment].
How you activate WPS on your router can be taken from its instruction
manual.
> Start WPS on your router by pressing the relevant buon.
> On the DIGITRADIO 380 CD IR, select [Press WPS Buon]. Take note of the
instructions on the display.
> If your router only supports the WPS PIN, select [PIN] on the DIGITRADIO
380 CD IR and take note of the PIN shown on the display. You then need to
enter the PIN in the router.