TechniSat DIGITRADIO 380 CD IR

71
DE
EN
FR
NL
If you select [No], the wizard closes and you need to perform the required
seings manually.
You will be taken through the seings in various steps.
> Under [Time format], select the desired display format for the time display
(Section 17.4) and press the OK buon.
> During the next step you must select via which source the time and date is to
be synchronised (for more information refer to Section 17.4).
If you have selected [Update from the Net], you must then enter the time
zone and summer time/winter time.
Depending on the time and date seings, some of the network seings are now
performed.
> Select whether the WiFi connection should remain active in standby mode as
well. Press the OK buon.
> Ensure that the device is within the reception range of the desired WiFi
network and that you have the access data. In some cases it may be
necessary to carry out some seings on the router. In this case, please refer
to the corresponding instruction manual.
Aer a search for available wireless networks you are shown the result.
> Select the desired wireless network and confirm the selection with OK. Select
Skip WPS to enter the password.
If it is a protected network you will be asked to enter the corresponding
access key.
> To do this, mark the respective character.
> Enter the selected character by pressing the OK buon.
Proceed in this way until the complete access key can be seen in the input
field.
To cancel the input, select and press the OK buon. If you make a
mistake, you can delete the last leer you entered by pressing .
> Then select and press the OK buon. If the password entered is
correct, a connection to the network is now established.
> When [Set-up wizard completed] appears on the display, press the OK
buon.