TechniSat DIGITRADIO 380 CD IR

70
17.5 Language
> Press the MENU buon and then select [System seings] > [Language].
> Using  or , select one of the available OSD languages and confirm by
pressing the OK buon.
17.6 Factory seings
If you change the location of the device, e.g. when moving house, it is possible that
the saved stations may no longer be received. In this case you can reset the device
to factory seings to delete all the saved stations and then launch a new scan.
> Press the MENU buon and then select [System seings] > [Factory
seings].
> Confirm by pressing OK.
> Use  or  to select > YES and confirm the confirmation prompt by pressing OK.
All previously stored stations and seings will now be deleted. Aer reseing,
you can start the set-up wizard (Section 17.8).
17.7 Soware update
From time to time soware updates may be provided which can contain
enhancements or error fixes. This ensures that the DIGITRADIO 380 CD IR is always
up to date.
> Press the MENU buon and then select [System Seings]> [Soware
Update].
> Select [Auto Update] if the DIGITRADIO 380 CD IR should search for new
soware versions periodically.
> Select [Check now] if you want to check immediately whether a new
soware version is available.
If a soware update has been located, follow the instructions on the display.
In order to find soware updates and upload them, the DIGITRADIO 380 CD
IR must be connected to the Internet. Do not switch o the DIGITRADIO 380
CD IR during the update process!
17.8 Set-up wizard
> Press the MENU buon and then select [System seings] > [Set-up wizard].
When switching on for the first time the set-up wizard starts automatically.
> As soon as [Run now] is shown on the display, select [YES].