TechniSat DIGITRADIO 52 - Manual scan; Volume adjustment (DRC); Deleting inactive stations; 8 FM mode

100 101
DE
EN
FR
NL
> Select the compression rate using < or >:
DRC HIGH - high compression
DRC LOW - low compression
DRC OFF - compression switched o.
> Confirm by pressing the SELECT/ MENU buon.
7.2.9 Deleting inactive stations
This menu item is for removing old stations and those no longer being received from
the station list.
> Hold the SELECT/MENU buon down briefly. Use the < or > buons to select the
[Inactive stations] item and press the SELECT/MENU buon.
The query [Delete] then appears as to whether the inactive stations should be deleted.
> Use < or > to select [Y] (Yes) or [N] (No) and confirm by pressing the SELECT/
MENU buon.
8 FM mode
8.1 Switching on FM radio mode
> Change to FM mode by pressing the DAB/FM buon.
>
[FM] is shown on the display.
7.2.7 Manual scan
This menu item is used to check the reception channels and can be used to align the
antenna.
> Hold the SELECT/MENU buon down briefly. Use the < or > buons to select the
[Manual scan] item and press the SELECT/MENU buon.
> Use the < or > and SELECT/MENU buons to select a channel (5A to 13F). Its
signal intensity will now be shown on the display. If a DAB+ station is being
received on a channel, the station ensemble name is displayed. The antenna can
now be aligned to the maximum signal intensity.
Stations with a signal strength below the required minimum signal intensity are
not transmiing a strong enough signal. Align the dipole antenna, if required, as
described in Section 5.3.2.
7.2.8 Volume adjustment (DRC)
The DRC menu item is used to set the compression rate, which compensates for
dynamic fluctuations and the associated volume variations.
> Hold the SELECT/MENU buon down briefly. Use the < or > buons to select the
[DRC] item and press the SELECT/MENU buon.