TechniSat DIGITRADIO 52

102 103
DE
EN
FR
NL
If a FM station with sucient signal strength is found, the scan stops and the
station is played. If an RDS station is being received, the station name appears
and, possibly, the radio text.
Please use the manual station scan for seing weaker stations.
8.4 Manual station scan
> Briefly press the < or > buons repeatedly to set the desired stations or
frequency.
The display shows the frequency in increments of 0.05 MHz.
8.5 Scan seings
In this menu item it is possible to set the sensitivity of the scan.
> Hold the SELECT/MENU buon down briefly. Use the < or > buons to select the
[Scan seings] item and press the SELECT/MENU buon.
> Select whether the scan should only stop for stations with a strong signal
[Strong Stations Only] or for all stations (including stations with a weak signal)
[All Stations].
When you switch on the radio for the first time, the frequency 87.5 MHz is set.
If you have already set or saved a station, the radio plays the last station set.
In the case of RDS stations, the station name appears.
To improve reception, readjust the dipole antenna (Section 5.3.2).
8.2 FM reception with RDS information
RDS is a procedure for broadcasting additional information via FM stations. Broadcasters
with RDS broadcast their station name or the programme type, for example. This is
shown on the display. The device can show the RDS information RT (Radio text), PS
(Station name), PTY (Channel type).
8.3 Automatic station scan
> Hold down the < or > buons for longer (2 to 3 sec.), in order to search
automatically for the next station with a sucient signal.
> Alternatively, you can press the SELECT/MENU buon.