TechniSat DIGITRADIO 52

110 111
DE
EN
FR
NL
10 System seings
All the seings referred to in this item are equally applicable in DAB+ and FM mode.
10.1 Date and time seings
10.1.1 Manually seing the date/time
Depending on the seing for time updates (Section 10.1.2), the date and time might
have to be set manually.
> Hold the SELECT/MENU buon down briefly. Use the < or > buons to select the
[TIME/DATE] item and press the SELECT/MENU buon.
> Use the < or > buons to select [Set Time/Date] and press SELECT/MENU.
> The first digits (hours) on the time flash and can be changed using the < or >
buons.
The > buon increases the value, the < buon decreases the value.
> Press the SELECT/MENU buon to accept the seing.
> The next time digits (minutes) then start to flash and can again be changed as
described above.
9.3.2 Switching o the alarm aer it has gone o
> Push the On/Standby buon to switch the alarm o.
> Press the SNOOZE buon to switch on the snooze function. By repeatedly
pressing SNOOZE, you can also select the length of the pause from 5, 10, 15 or
30 minutes.
The possible snooze time depends on the set alarm duration, so that, at an alarm
duration of 15 mins, you can set a snooze time of 5 mins or 10 mins.
The alarm symbol appears in the display again if the alarm repeat is set to Daily,
Weekend or Work days.
9.3.3 Switching o the alarm
> Repeat the steps described under „9.3.1 Wecktimer einstellen“ and then select
> [OFF] in the last step of the configuration. Save the seing by pressing the
SELECT/MENU buon.