TechniSat DIGITRADIO 586 User Manual

63
DE
EN
FR
NL
12.8 Signal strength
> Press the INFO buon several times until the signal strength is displayed.
> The level of the bar indicates the current signal strength.
Stations with a signal strength below the required minimum signal intensity
are not transmiing a strong enough signal. If required, align the antenna as
described in section 7.3.1.
By pressing the INFO buon several times, dierent information can be
scrolled through, such as station type, multiplex name, frequency, signal error
rate, data bit rate, station format, date (depending on the active source).
12.9 Dynamic Label Plus
If supported by the programme provider, the Dynamic Label Plus service also allows,
for example, the name of the current programme or the track and artist to be
displayed.
12.10 Seing DRC
The compression rate balances dynamic fluctuations and thereby any volume
variations that occur.
> Press the MENU buon and select > [Volume Adjustment], to select the
desired compression rate.
> Use  or  to select the compression rate:
DRC high - high compression
DRC low - low compression
DRC o - compression switched o.
> Confirm by pressing OK.
12.11 Deleting inactive stations
> Press the MENU buon and use  or  to select > [Delete inactive
stations].
> Confirm by pressing OK.
> Using  or , select > [Yes] and confirm by pressing OK.
Minimum signal intensity
Signal intensity

TechniSat DIGITRADIO 586 Specifications

General

Brand	TechniSat
Model	DIGITRADIO 586
Category	Radio
Language	English