EN10
RF Transmission Procedure:
` The weather station automatically starts receiving transmission from outdoor thermo
sensor after batteries inserted.
` The remote sensor will automatically transmit temperature signal to the Weather Station
after batteries inserted.
` If the Weather Station failed to receive transmission from outdoor sensor (“- -.-”display on
the LCD), press and hold the “-/CH” button for 3 seconds to receive transmission
manually. RF icon “ ” flashes on the LCD of the Weather Station to receive the
remote sensor.
` If the weather station is used with 2 or 3 transmitters, press “-/CH” button shortly to
display CH2, CH3 or cyclic display.
Maximum/minimum temperature/humidity
` Press “MEM” button once, the LCD will display maximum value of temperature/ humidity.
If the “MEM” button is pressed again the minimum value is displayed.
` While displaying MAX or MIN values, there is “MAX” or “MIN” on the LCD.
To Next Page
Loading...
