EN9
buttons to set the hour.
` Press “ ” button to confirm your setting. The minute of the alarm time starts to
flash. Use the “+” and “-” buttons to set the minute.
` Press “ ” button to confirm your setting. The snooze time starts to flash. Use the
“+” and “-” buttons to set the snooze time. The snooze time can be set from OFF to 60
minutes.
` Press “ ” button to confirm your setting and to end the setting procedure.
Please note:
` If there is no valid operation within 20 seconds, the station will automatically return to
normal time mode from the alarm time set mode.
` The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In
this case the alarm will be repeated automatically after 24 hours.
` Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst
the alarm signal is heard.
Switching off the alarm signal
` Press any button except the “SNOOZE/LIGHT” button to stop the alarm signal. It is not
necessary to reactivate the alarm. It switches itself automatically to the alarm time which
has already been set.
Snooze function
` When the alarm is ringing, press the “SNZ” button the alarm mode to get to snooze mode.
The alarm signal sounds again after already been set. If OFF was selected in the
SNOOZE time setting, the alarm will not repeat.
To Next Page
Loading...
Need help?
General
