WS 9178 Manual
Open the battery compartment on the rear
side of the base station and insert 2 x AAA
batteries. Please observe the correct polarity.
Close the battery compartment.
After inserting the batteries, all the icon on the
LCD display will briefly light up for 3 seconds.
The base station will now start to make a
connection to the outdoor sensor. This
operation takes about 3 minutes and is
displayed by a flashing reception radio
antenna symbol in the “OUTDOOR” display
area on the base station.
Manual time setting:
Press “SET” for about 3 seconds to confirm
your setting, the 12/24 hour mode display
To Next Page
Loading...
