EN6
The alarm will sound for 2 minutes if you do not deactivate it by pressing any button.
In this case the alarm will be repeated automatically after 24 hours.
Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times
whilst the alarm signal is heard.
Switching off the alarm signal
Press any button except the “SNOOZE/LIGHT” button to stop the alarm signal. It is not
necessary to reactivate the alarm. It switches itself automatically to the alarm time which
has already been set.
Snooze function
Touch the “SNOOZE/LIGHT” button the alarm signal sounds to get to SNOOZE mode. The
alarm signal sounds again after already been set. If OFF was selected in the SNOOZE time
setting, the alarm will not repeat.
RF Transmission Procedure:
The weather station automatically starts receiving transmission from outdoor thermo
sensor for outdoor temperature & humidity after batteries inserted.
The outdoor sensor will automatically transmit temperature and humidity signal to
the Weather Station after batteries inserted.
If Weather Station failed to receive transmission from outdoor sensor (“- -”display on
the LCD), press and hold “-/CH” button for 3 seconds to receive transmission
manually. RF icon “ ” flashes on the LCD，The Weather Station to receive the
outdoor sensor.
If the weather station is used with 2 or 3 transmitters, press “-/CH” button shortly to
display CH2, CH3 or cyclic display.
P re ss "-/C H "
P re ss "-/C H " P re ss "-/C H " P re ss "-/C H "
A u to m a tic A u to m a tic
A u to m a tic
5S 5S
To Next Page
Loading...
Need help?
General
