⇒ Heating cycle
Before starting up the machine and beginning heating, the cycle that the machine is to carry out must be set;
please follow these steps:
I° - Set heating temperature
II° - Set whether the mixture requires emulsifying
III° - Select whether the whole or half the tub is to be heat
After programming the machine heating can be started.
A USEFUL EXAMPLE:
Quantity of mixture to be heat = 60 litres (MIXTRONIC 60)
- Chosen heating temperature = +85°C
- Mixture to be emulsified ? = YES
- Quantity of mixture to be heat = 110 litres (MIXTRONIC 110)
- Chosen heating temperature = +85°C
- Mixture to be emulsified ? = YES
PROGRAMME:
Lights (led) off
If on, press the money box
and it will switch off.
Now that you have programmed the cycle, pour the liquid into machine
and start by pressing the START CYCLE push button.
While operating, please press the MANUAL push button when you start pouring in solids (powdered milk -
sugar - etc.), so as to accelerate dispersion,: the emulsioner will start and will operate for roughly 2 minutes
before stopping. If 2 minutes is not enough, please press the push button again.
To Next Page
Loading...
