Technogym element leg extension - Page 27

27Leg Extension
C
B
04194032
A
Replacing the cable
- put in the screws (A), put in the
adjuster (C), and tighten the lock
nut (B);
- replace the back panel of the weight
stack (following the instructions
found in the section
Removing the
weight stack panel in reverse order).
DANGER
ALWAYS use cables supplied
directly by Technogym.
The cables must always be replaced at
the first sign of wear, even if it only affects
the outer rubber protection.
WARNING
Every month, carefully inspect
the condition of the cables.
Identification of the manufacturer
and the equipment
Description of the equipment
Technical data
Safety labels and devices
Packing
Place of installation
Unpacking
Lifting and handling
the equipment
Adjusting the equipment
Routine maintenance
Replacing
the padded components
Replacing the cable
Adjusting cable tension
Removing
the weight stack panel
Technical Service
Storage
Disposing of the equipment
Using the equipment
Contents