10
Cables Crossed
Lifting and moving the equipment
Before moving the equipment, firstly release it from the fastening and remove the
fastening beam (follow the instructions for assembling, in reverse order).
To move the equipment it is necessary to use three wheels: two fixed wheels and
one castor wheel.
WARNING
Move the equipment with great care to avoid it tipping over.
The wheels for moving the equipment snap on underneath the feet of the
equipment, after it has been lifted, and are held in place by the special straps.
Lift the equipment from the weight stack side using a transpallet or lift truck.
WARNING
Insert a rigid board between the equipment and the transpallet forks.
To Next Page
Loading...
