14
I
L
M
N
Cables Crossed
Assembling the equipment
Pass the cable through pulley (I); check the cable is correctly positioned in the
pulley groove.
Insert the rubber gaiter (L) and the attachment (N); then tighten the
screws (M).
Lower the rubber gaiter (L).
Securing the equipment to the ceiling or to the floor.
Adjust the equipment.
If the Cables Crossed are obtained from two Ercolinas, remove the pulley mount.
To couple together more Cables Crossed or one Cables Crossed with one or more Ercolina(s), please refer to the instructions for
"Joining the equipment units" as found in the Ercolina - Ercolina Rehab User manual.
To Next Page
Loading...
