Technogym Selection Chest Incline - Page 13

13
Chest Incline
L
I
H
G
F H
Lifting and moving the equipment
To remove the easy start device proceed as follows:
- remove plug (F) from the back of the weight stack panel to access screw (G);
- remove screw (G) and the two screws (H) from the opposite side;
- remove the weight stack pin, lift crosspiece (L) using the levers, then insert
the pin to secure crosspiece (L) at the top;
- remove the easy start device (I) without operating it.
To reassemble the easy start device, carry out the above steps in reverse order.