EasyManua.ls Logo

Technoline WS9132 - Alarm Signal Management; RF Transmission Procedure

Technoline WS9132
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WS9132 Manual
Please note:
If there is no valid operation within 20 seconds, the station will
automatically return to normal time mode from the alarm time set
mode.
The alarm will sound for 2 minutes if you do not deactivate it by
pressing any button. In this case the alarm will be repeated
automatically after 24 hours.
Rising alarm sound (crescendo, duration: 2 minutes) changes the
volume 4 times whilst the alarm signal is heard.
Switching off the alarm signal
Press any button except the SNOOZE/LIGHT” button to stop the
alarm signal. It is not necessary to reactivate the alarm. It switches
itself automatically to the alarm time which has already been set.
Snooze function
When the alarm is ringing, press the SNZbutton the alarm mode
to get to snooze mode. The alarm signal sounds again after already
been set. If OFF was selected in the SNOOZE time setting, the
alarm will not repeat.
RF Transmission Procedure:
The weather station automatically starts receiving transmission
from outdoor thermo sensor after batteries inserted.
The remote sensor will automatically transmit temperature signal to
the Weather Station after batteries inserted.

Related product manuals