EN2
OVERVIEW
A – Front view
A1: Place mobile device (not included) on top for wireless charging
A2: Alarm 1 ON icon A3: RADIO/SLEEP button
A4: ALARM 1-2 SET/ON-OFF button A5: CLOCK SET/MEMORY button
A6: DOWN button A7: Alarm 2 ON icon
A8: Mood light A9: SLEEP icon
A10: SNOOZE button A11: DIMMER button
A12: Wireless charging ON icon A13: VOLUME SET button
A14: UP button A15: PM icon
B – Top view
B1: Charging coil (charging target circle)
C – Back view
C1: Heat release vent C2: AC wall outlet
C3: 5V-2500mA AC/DC adapter C4: Insert DC jack to power up your unit
C5: USB charging cable (not included) C6: Mobile devices (not applicable for tablet /
iPad)
D – Bottom view
D1: Backup battery ( 1x CR2032, not included)
Please read these instructions carefully and keep the manual for future reference.
TO POWER UP YOUR CLOCK RADIO
Plug in the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back of the
unit. The display shows
the default time (at Lo-dim brightness). Press once to turn the time display to high
brightness if need.
TO INSTALL BACKUP BATTERY ON YOUR CLOCK RADIO
Your clock radio requires one lithium cell “CR2032” battery (not included) to provide backup power to
it in the event of a temporary power interruption.
1. Place your clock radio face down on a flat and soft surface.
2. Use a coin to turn the battery cover anti-clockwise at the back of your unit.
To Next Page
Loading...
