Operation/installation/service manual MACERATOR TOILETS
Manuale di utilizzo / installazione / manutenzione TOILET MACERATRICI
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
paper towels or similar products. Tecma recommends using Thetford Aqua-Soft.
WARNING: Read and understand the warnings listed in this document before
installing, using, or servicing the system. Failure to comply with these warnings may
cause malfunctions, injuries, damage, loss of the property, and electrocution. Any
modification applied to Tecma's product may result in loss of the property, injuries, or
electrocution.
2.0 OPERATING THE SYSTEM
2.1 All-in-one control panel
2.1.1 One button
Press the “AFTER USE” button to start the automatic flush cycle, after which the toilet will be
refilled with a small amount of water, ready for the next use.
2.1.2 Two buttons
Press the “BEFORE USE” button before using the toilet. This will fill the toilet with a small amount
of water. Press the “AFTER USE” button after using the toilet. This will start the automatic flush
cycle, which will empty the toilet.
NOTE: The All-in-one control panel allows you to adjust the amount of water used during the
flushing cycle. A regulator placed at the back of the panel increases the amount of water if turned
clockwise, or decreases it if turned anticlockwise. The recommended water level is 1 cm above the
ceramic outlet.
To Next Page
Loading...