Operation/installation/service manual MACERATOR TOILETS
Manuale di utilizzo / installazione / manutenzione TOILET MACERATRICI
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
www.thetfordmarine.com / TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
Manual rev 25.2014 ©TECMA SRL
2.3 Argent control panel
2.3.1 One button
Press the “FLUSH” button to start the automatic flush cycle, after which the toilet will be refilled
with a small amount of water, ready for the next use.
2.3.2 Two buttons
Press the “BEFORE USE” button before using the toilet. This will fill the toilet with a small amount
of water. Press the “FLUSH” button after using the toilet. This will start the automatic flush cycle,
which will empty the toilet.
NOTE: It is also possible to adjust the amount of water used during every flushing cycle directly
from the connected remote control unit. A specific regulator placed on its rear increases the
amount of water if turned clockwise, or decreases it if turned anticlockwise.
The recommended water level is 1 cm above the ceramic outlet.
To Next Page
Loading...